This knife was made from 52100 ball bearing steel. This steel takes a very fine grained edge and has nice retention. This steel has been heat treated to 63/64HRC. One notable quality of 52100 is its relative toughness when compared to other carbon steels at comparable a hardness. This knife has a full convex grind which is done on a rotary platen. The handle of this knife is African Blackwood and curly pear from Missouri. This knife has a forced patina which creates a nice base layer patina. I have also tempered the tangs back and left the temper colors at the ricasso.

Specs:
Blade Length: 230mm
Heel Height: 51mm
Handle Length: 130mm
Width of spine out of handle: 2.81mm
Width of spine halfway down: 1.98mm
Width of spine 4cm from tip: 1.44mm
Width of spine 2cm from tip: 0.98mm
Overall weight: 199g